EC(4) - Device Drivers Manual

EC(4) - Device Drivers Manual #

EC(4) - Device Drivers Manual

NAME #

ec - 3Com EtherLink II (3c503) Ethernet device

SYNOPSIS #

ec0 at isa? port 0x250 iomem 0xd8000 irq 9

DESCRIPTION #

The ec device driver supports 3Com EtherLink II (3C503) Ethernet cards.

The EtherLink II supports two media types on a single card. All support the AUI media type. The other media is either BNC or UTP behind a transceiver. Software cannot differentiate between BNC and UTP cards.

The ec driver supports the following media types:

10base5

Set 10base5 (thick-net) operation.

10base2

Set BNC (10base2/thin-net) or UTP operation.

For more information on configuring this device, see ifconfig(8). To view a list of media types and options supported by your card try “ifconfig <device> media”. For example, “ifconfig ec0 media”.

DIAGNOSTICS #

ec0: wildcarded IRQ is not allowed The IRQ was wildcarded in the kernel configuration file. This is not supported.

ec0: invalid IRQ <n>, must be 3, 4, 5, or 9 An IRQ other than the above listed IRQs was specified in the kernel configuration file. The EtherLink II hardware only supports the above listed IRQs.

ec0: failed to clear shared memory at offset <off> The memory test was unable to clear the interface’s shared memory region. This often indicates that the card is configured at a conflicting iomem address.

SEE ALSO #

ifmedia(4), intro(4), isa(4), hostname.if(5), ifconfig(8)

OpenBSD 7.5 - September 7, 2008